Jump to content
I Forge Iron

Charcoal heat time


Deep Forest Tinker

Recommended Posts

I recently switched from Coal to Charcoal due to my coal supplier shutting his doors.  Still using the same basic forge layout with charcoal as I did with coal, but with two minor changes.

With coal, I used a hair dryer connected to a copper pipe, which fed into a stainless steel pipe with holes drilled in in for the air blast ( From the bottom ) , to get consistent heats, I had to all but seal the copper pipe into the Stainless pipe, With charcoal, even with the hair dryer on the lowest setting, in order to get a good heat and keep from burning my charcoal up very quickly, I had to pull the copper out of the stainless, now I leave about a 1-2 inch gap between the pipes for the airflow, and in some cases offset the copper so only about half of the opening on either side line up. 

Second thing, as mentioned above, is the fire size, with coal, I typically had a trench about 1.5 firebricks long, by about 1 firebrick deep, with charcoal I found it best to shorten up the length to about 8 inches ( .75 firebrick im thinking ) and nearly double the depth of the fire trench. 

I have yet to attempt to forgeweld since moving to charcoal, but I am certain I can get the temps needed as it takes about 3 minutes to get a piece of O1 half inch rod stock up to forging heat from cold, and once its been in the fire once, about 10-15 seconds to get it back to forging temps, I actually stick the piece back in the fire, and count out loud because the first piece of metal I stuck in the forge after tinkering with it came out sparking and very VERY yellow and burned, I think I left it in there for about 5 minutes as prior to the changes it would come out dull red after 5 minutes. 

good luck, play around with it. 

Link to comment
Share on other sites

with a side blast, you are limited to about 6" of heat with charcoal, not so with coal. Further you will find that the hot spot is about an inch closer to the tyere with charcoal than coal. This isn't an issue, as you can pile an inch of coal on top of the hearth, and lay your stock on it. This is using a 3/4-1" ID tyere (3/4" schedule 40 pipe is about 7/8"). With charcoal your waisting fuel going larger, you need multiple tyere to do that. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...