Frank Turley Posted February 19, 2012 Posted February 19, 2012 My old cast iron forge, maybe a Lancaster, dates waaay back, and it came with two lugs integral to the casting. Each lug has a 5/8" horizontal hole. This design was intended to contain a pivoting work support which I made of 1/2" D wrought iron. The supporting leg is likewise 1/2" D with a turned eye at the top. I made a 5/16" D slide to hold shorter lengths, as shown. Quote
pkrankow Posted February 19, 2012 Posted February 19, 2012 That is a very nice setup. Simple, and effective. I'll have to remember this. Phil Quote
CurlyGeorge Posted February 19, 2012 Posted February 19, 2012 Not sure what brand that my shop forge is. But it also has the lugs on it. I used the one on the right to hold one end of a 1/2" rod to hold a tong rack that I made. I have a stand that sets on the floor and adjust to height to hold my stock while in the fire. Those lugs are handy. :) Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.