Sign in to follow this  
Steeler

Gift Anvil Build

Recommended Posts

I built this little anvil as a gift for a good friend. I started with a 2" thick drop of mild? steel that had a convenient curve for the underside of the tail and a flat surface for the face. A one inch thick drop with a nice big hole in it was cut and welded to form the base. I turned the horn on my ancient lathe out of a two inch diameter drop of mystery steel shaft. All the welds are as close to 100% as I could make them with one-eighth E6011 rod.
The anvil weighs 58 lb. and has a 2" X 10" face with a 3/4" round hole, a 10" X 5.5" base and a 6" horn.
Accesories are a hot cut made from the tip of a wood splitting maul, a 2" built up and remachined trailer ball, a 1.25" ball bearing welded to a shank, and a 1" thick hole punch saddle plate with an assortment of hole sizes.
I decided to try hardening the face, figuring that there is at least a little carbon to work with. Heating took about three hours in my jury rigged fire brick oven with tiger torch burner to achieve a dull red color. I boosted the heat on the face with oxy-aceteline and then quickly quenched with buckets of water and the garden hose full on.
The face did harden somewhat. A ball bearing dropped from 5" gives a consistant rebound to 3".

post-9588-034100400 1276924401_thumb.jpg

post-9588-014996300 1276924454_thumb.jpg

post-9588-044485100 1276924559_thumb.jpg

Share this post


Link to post
Share on other sites

so after "face hardening" what is the bounce like?

nice looking anvil btw



Thanks DennisG. It was so late and we had such a long day, that we didn't think to try a hammer bounce test. After the bearing drop test, it was high fives, big grins and good night. The anvil is on its way to its owner's home and I look forward to hearing about how it works for my friend and what he forges with it.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this