Search the Community
Showing results for tags 'throwing axe'.
Ok so this is my first attempt at forging a small axe. Some friends of mine have recently taken up the hobby of axe throwing and everyone there uses these off the shelf home depot hatchets. So I wanted my friends to stand out a little bit. This was made using a bell pien hammer head. I forged out the whole thing by hand although I wish I had a press for the end even just to make the thing a little easier to hold onto with my tongs. I had to start out by holding the piece through the eye and started working out the axe and of it. This was definitely a mistake as I just couldn’t get a decent grip so a lot of my time was wasted fiddling with the hold I could get. Once I had the blade shaped I had initially intended to cut off the back part of the hammer but then I saw I picture online of an axe with a spike and I loved it so I drew that out. Quickly I realised that a square taper at the back was super easy to hold with my v bit tongs and so I forged the spike halfway and worked way more on the blade which helped out immensely with straightening out the blade and getting it to a shape I liked. Once that was done I finished forging out the spike. I used an angle grinder with a 40 grit flap disk to take out most of the deep hammer marks. I had never used the angle grinder before but it worked really well. Finally I heated up the whole thing to an orange heat and quenched the blade about half way up into the oil for a few seconds until the temp on the spike was a red then I dunked the rest of it into the oil. I still need to clean off the oil residue and put an edge on it but overall I like the shape so far.