Search the Community
Showing results for tags 'rex burner'.
Found 1 result
Hi, my name is Jim. I am 37, a father of a two & three year old. I am a carpenter by day & well a busy father after. As my life is chaotic and I'm always busy either with work or taking care of others I needed some serious me time! So the adventure began, first it was straight razors but that just wasn't enough for me. I buy, sell & restore them. I got involved with the forums but I don't feel as if I actually fit there. I have nothing bad to say it's just you can't fit a square peg in a round hole. Now after taking a serious interest in blacksmithing & after long careful consideration I started buying tools. As I stated in a father and everyone knows that means "on a budget" so I bought a used 70# anvil without a makers mark, the only mark it has is on the left foot a 7 stamped in there. I paid just over a $1 per pound. I'd like to I.D. It but I have so many more important questions, like #1 being I have bought a forge to save time and hey the price seemed right ($130.00) it came with a 1" Rex burner and the forge inside diameter is six inches round by twelve long, made with refractory cement and by eye I'd say near 1/4 inch plate steel. So from what a have read it seems the burner is more than sufficient for the space. My question is do you think this will work out well and most importantly how do I tune the burner? I have played around with different air/fuel ratios and I just can't seem to get a " jet like" blue flame. In fact all I'm getting is a weak flame or I get what appears to be an invisible yet loud flame? I can't help but wonder if I should have went with coal?? Anyway I am going to end it here as I have so many questions I don't want to over load one post. Any help getting this burner flowing right and opinions on my setup even constructive criticism is welcome. I just want to learn & learn the right way. Sorry that I'm all over the place but I wanted to introduce myself and get my first questions out. Thanks, Jim.