Search the Community
Showing results for tags 'no 1'.
Found 1 result
Blorph posted a topic in Bellows, BlowersA while back I bought for $65 a forge blower; and have been restoring it ever since. I've been attempting to remove both the grease and rust without power tools (since I'm a broke teenager), with electrolysis and simple green and a wire brush for months now. Here are some of the parts after I've cleaned them up a bit: Funny thing is that I can hardly find any information about the forge blower anywhere on the internet. Perhaps a couple listings on ebay, but that's about it. Gear casing that I just separated today. Any ideas of how I can weld the broken piece back on? Recently removed stand Not sure if I can do electrolysis on this fan. The gear is stuck. By that I mean that I can't get it out, but with the handle attached and the other gear installed, it spins rather well. I just want to get it out along with the worm gear so I can actually remove the grease and rust. This and going to the hardware store (at the start of the school year) are my only two obstacles currently. Also acquiring/building a forge without welding equipment. The stand has a rusty bolt that I was able to loosen a tad bit after doing likely the sketchiest electrolysis cleaning ever with the entire stand in a garbage can with holes in the bottom and double lined with garbage bags. Any suggestions on how I can push out the axle pin on the inner gear or the brass bushings would be wonderful. Rust/Grease removal as well, including information about this particular blower.