Search the Community
Showing results for tags 'installation'.
Hey Folks, I´d like to ask for your advise on a project I want to start soon. My shop is half oudoors so I have a roof over the head but literally no walls. Until now I have always had my forge standing just free and hoped for good wind... But as you can imagine I take quite a lot smoke and dust and I mustn´t damage my body with stuff like that at my age. So I want to install a smoke hood over my forge. The only problem is that I only have a very limited budget of about 180$. So I guess I have to take a DIY-solution. After some research and discussions with some fellow blacksmiths I came to the conclution that this design (I know I ain´t very good at drawing...) would give me the biggest bang for my buck: This is my shop: And this is the design I´d like to try: The hood will be built from an old oil barrel, cut out on the front and bent upside to form a guiding-shield. On top of that the chimney will be installed reaching through the roof of my forge with min. 8" diameter. Would you also advise me to do it like that or do you have a solution (any construction plans) that might be more (cost)effective? I´d be very happy about any advise you give me! - Daniel