Search the Community
Showing results for tags 'gas burners'.
Found 2 results
-
Here it is finally. Spanky spent a lot of her valuable time reading the galleys and editing for me or this would be a real mess. She won't accept credit on the document as the editor either. Thank you Spanky! T Burner Directions finished.pdf Here's hoping this clears up some of the questions. Frosty The Lucky. T Burner Directions finished.pdf
-
Started working on my forge's twin burners this week. So far, everything is turning out great. I have not tested this design yet, but plan to do so soon. I started off by taking a close look at my TurboTorch tips that I use at work (Acetylene gas). Here's a picture of the TurboTorch tip (A11). I too extra notes on the brass section of the torch tip, where the gas begins to mix with air. The gas flows from the regulator into a small chamber, with a very tiny hole machined in it. This little hole sits just before the air intake, which is proportion
