Search the Community
Showing results for tags 'forge burner'.
Found 3 results
-
I am going to go see about building a forced air burner, Using the design off of this burner I have here. I would like to know if anyone has done one like this before and the problems they ran into? If i build it exactly as shown will is work well and safely? Also for the flared end i was going to take the 1 1/4 and forge it into the flared fitting described here with a 1 1/2 opening. Thanks and merry smithing, Matthew
-
Propane forge burner. Based on Ron Reil design. Modified design to use a 1" x 1 1/2" reducer as the discharge opening rather than a shaped flare. Works very well with a #57 orifice at 5200 ft elev.© Mike Romo, 2013
-
Hey guys, I built two burners this week after work. Both are 3/4". One is a Ron Reil style with the mig tip mod. The other is my interpertation of a hybrid style ...except not as nice ...or as good functioning but I did it anyways lol....What i would like to get is some opinion on flames of each burner. I know what i think but i am curious to learn what others see. My goal here is education for myself and being able to build the best burner that i can. I am also open to any suggestions or critiques. I do not have any psi info on the flames in question because i have them each running on a small 1 lb propane cylinder.Though i will be making a tractor supply store run this week. Also you may note thay the hybrid type does not have a choke sleeve on at this pic but it does have one...Thank you in advance for any and all input. P.s excuse the mess ..the maid is on strike, something about labor laws and my mom? Not sure couldnt hear her over the drill press
