Search the Community
Showing results for tags 'durable'.
Found 1 result
Hello everyone, this is my first post on I Forge Iron! Thank you for all the hard work you do both maintaining the site, and responding to questions. It's a relief to a newbie like me to be able to get answers from pros who've been there, rather than guesswork. My question is, are there any gas forges that you would recommend? I don't have any welding experience yet, so I can't make one. I was looking at the Whisper Momma but before I took the plunge, I wanted your input on if there is something better out there, or more suiting, if you're willing. My main focus in blacksmithing will be tool smithing, and general functional blacksmithing rather than artistry/sculpture. Also, I will probably do architectural/artistry work for practice and gifting, but not for public use. What I'd like from a gas forge will probably seem like I'm asking for the moon, but here goes. I'd like a forge that has a clamshell design (not necessary, but seemingly helpful for larger work), or at least a fairly spacious interior that allows for a 7+ inch width, 3+ in height, 5+ in. depth. Basically, enough for small plates (i.e. for coal shovel, smithin' magician), general tools (hammer, tongs) etc. I'd like for the forge to be of a venturi type. I will be working without electricity, so a blown forge and natural gas is a no go. A forge that has enough heat for forgewelding, specifically, hot enough for chain links, basket welds, etc. One that is also safe, reliable, and gas efficient. While not necessary, one that is easy to repair would also be helpful for me. Also, while these don't have to do with picking a forge, they kind of are related safety wise. About how long does it take to cool off once it's shut down? I figured checking hoses, making sure there aren't any leaks, don't tip the propane, stabilize and keep the forge on inflammable materials are all essential practices, but are there any other safety concerns for a gas forge that I should know about? Any particular size of propane tank that you would recommend, and if it isn't too invasive, the typical cost I'd be looking at? I read a couple articles on iforge, about protecting the refractory with stainless steel or kiln shelving. Are there other methods of protecting the refractory from flux, but can still take the heat? Thanks again for your help and your interest, I appreciate it.