Search the Community
Showing results for tags 'door'.
I was commissioned to reproduce a latch set for a customer in Arizona, and a Speakeasy door and grill for a local customer. Small 7.5" x 14" door and grill Plasma cut 14 ga, weld on hinges, with a squirrel tail handle latch set. This is the original latch set I was asked to reproduce. Its a bit crude but the customer really liked it. the end of the handle and the clip are slightly forged out and then there are very thin fuller marks on the ends, so i duplicated that. I was not able to match the 3/8" rivet because the ones made now have a slightly smaller head. I did
Hey everyone! Here's a gate that we did a few years ago, but it's one of my favorite projects we've done so I thought I'd share it. The gate is 5 ft tall, by 39 inches wide, I think. We cheated a bit, it's not all hand forged, a lot of it is plasma cut from a 3/8 hot rolled plate. But the leaves are hand forged. We painted it with a tarnished copper green, sprayed a watered down black paint all over it light but enough to make it run down the gate a bit. And the leaves have been gold brushed. Hope ya'll like it! Have a good weekend!