Search the Community
Showing results for tags 'chase'.
Got a Question...... Thats nothin new is it?? LOL OK So I went to the metal yard today looking for some metal for a firepot and side draft forge hood. After looking for several hours I found a piece of 1/2 sheet big enough for 2 fire pots. After getting home I found that is it Stainless Steel!!!! So my question is this. Will 1/2" SS hold up as good or better than 1/2" mild steel??? Thanks, Trip
Hey yall, Well I just came in from working on my new masonry forge (I will post photo's when it's done), I am getting close to having to build a fire pot. Although it is a masonry forge it will have a metal fire pot, I know I want to make it out of 3/4" thick steel, but I don't know how big I should make it, 10"X12" OR 12"X14", and how deep 4" OR 4.5"? Also, should I put in a clinker breaker? Also I would like to share with yall how I start my forge fires. I am posting this because my good friend Dave Custer of Fiery Furnace Forge LLC, has a REAL problem on how I do it. What I do is go down to the corn field and pick up corn cobs the combine discards, then when I get back to the shop I soak them in kerosene over nigh, then I set them back for when I want to start a forge fire. So what I do is, I take one KCC (kerosene corn cobs) and set it over the clinker breaker. Then all I have to do is light it with a match and put coke on it, and with just a little air I have a fire that is hot enough for forging in less then a minute. So what do yall think about it? Chase Check out my blogs at http://chewinthefatwithchase.blogspot.com/ & http://kentuckyheritagehomestead.blogspot.com/