Search the Community
Showing results for tags 'base'.
Found 3 results
Got a little time today to start a stand for my new anvil. Plan on using this both inside and out so incorporated in some legs that are adjustable so can get it close to level wherever it decides to rest. Didn't have much time today so this is a work in progress. Started out with a 1" steel plate for the base. The legs are made from 2-1/2" x 1/4" square tube. The feet are made from 4" SCH 80 pipe that have 1-1/8" Grade 8 bolts for the adjustment. The bolts are welded to a piece of 1/2" plate with the nut concealed up inside of the 2-1/2" tube, The 4" pipe has a 1/2" plate welded with a 1-17/16" hole punched into it and then welded to one end of the 4" pipe with a nut welded on the top side. There is enough bolt so there is 4" of adjustment so the stand can be used for different height anvils to get the correct working height. The lowest setting I have it would be about 31" where 33" is about the perfect height for me. Still have to come up with a attachment system that will work for the Fisher and the Fawcett anvils I have. There will be a hole through the 1" plate that will be inline with the pritchell hole and the hardy hole. Only got about 3 hours into it today so will post some pictures when it receives more attention. Plan on leaving drilling holes in the plate for hammers and other tools. The anvil that is setting on there in the picture is an 80lb Fisher and though I didn't weigh the stand, I'm guessing it is a little more than the weight of the Fisher.
Hi Everyone I am soon taking delivery of a new 15kg/C41 AIr Hammer. I have received the following guide (see photo) from the company with regards to installing a foundation but I have an issue with my landlord being fussy about me putting in a foundation. What else can I do? I want to ensure the hammer is secure yet does not crack the existing floor. It is not a very big hammer so does it need a foundation? Would a wooden base/block or maybe rubber matting work? Rich
Hello all, I have been using a brake drum forge I made much like the ones seen on the internet. It works and can reach the temperatures I need, so much so I ended up burning off some hard work I put into some rebar :( Part of learning I guess! My problem is this, to keep coal from falling down my tuyere I believe it's called, I got some sheet metal I found at the Brimfield Faire. It was like this really thin tinny looking sheet used for decorating restaurants, sort of like corrugated steel. Anyways, I cut a circle of it and put it in the bottom of the forge and drilled holes into the center. It worked for a little while but now I have air coming up out and around the plate rather than just through the holes. I think it's because it has warped so much from the heat it was never meant to experience. I couldn't get a clear picture since its filled with coal. I am now burning basically an entire brake drum of coal constantly, I don't really have a center of heat, its all going. This is really wasteful I feel. I was wondering if you guys knew of any good material or piece to put in the bottom of a brake drum forge (or any forge) that will work much better? I do have some old BBQ grill....grill. The bars seem too far apart though. Whatever you guys could recommend would be great, thanks! EDIT: I was perusing more, I have no way of actually welding something, I don't mean forge welding. So it would be next to impossible for me to weld some bars into the pipe.