Search the Community
Showing results for tags 'door'.
Found 2 results
I was commissioned to reproduce a latch set for a customer in Arizona, and a Speakeasy door and grill for a local customer. Small 7.5" x 14" door and grill Plasma cut 14 ga, weld on hinges, with a squirrel tail handle latch set. This is the original latch set I was asked to reproduce. Its a bit crude but the customer really liked it. the end of the handle and the clip are slightly forged out and then there are very thin fuller marks on the ends, so i duplicated that. I was not able to match the 3/8" rivet because the ones made now have a slightly smaller head. I did grind an angle on the latching end of the handle because the clip is angled and this allows the latch to friction fit nice and tight, so the doors do not rattle. I had 2 hours tooling up a couple jigs, and about 5 hours cutting, forging, drilling holes, assembling,....... I had to heat all of them up to orange heat so the unforged parts would scale up and be wire brushed, for a more consistent look that the customer asked for, the orange heat removes all the mill scale and so the rusted patina will take more evenly over the piece. I used scale dust on the piece to work the handle loose from the mounting plate its riveted to. Scale dust is very abrasive and effective at getting the handles loosened up so the function nicely. 8 sets forged and riveted together. Tomorrow I will pull them out of the muriatic acid Spray with hydrogen peroxide to rust them, then apply wax to darken the rust up to match the original.
Hey everyone! Here's a gate that we did a few years ago, but it's one of my favorite projects we've done so I thought I'd share it. The gate is 5 ft tall, by 39 inches wide, I think. We cheated a bit, it's not all hand forged, a lot of it is plasma cut from a 3/8 hot rolled plate. But the leaves are hand forged. We painted it with a tarnished copper green, sprayed a watered down black paint all over it light but enough to make it run down the gate a bit. And the leaves have been gold brushed. Hope ya'll like it! Have a good weekend!