Thanks Latticino.
Typed Dawn 21/2 B Blower into Google and found the blower in question. Is a commercial model original manufactured for dust extraction etc.
2850 RPM was the speed mentioned, but I believe in a forge application this speed would have to be greatly reduced. Have decided to wait until I have built the
forge and sort it out by trial and error.
Could be described as almost new. It would not have been used as a forge blower although its design and appearance greatly resemble one. It is of heavier construction
than the usual blower designed for forge work. Not sure what it was used for previously if it has been used at all, paint is still unmarked around the outlet pipe.
The unit is marked DAWN 2 1/2 B
Did intend to drive it direct with a 1420 RPM electric, If this is to fast will use pulleys to obtain the correct RPM.
Have thought of using a temporary set up utilising a B&S engine or a tractor belt pulley to check the air flow at various speeds.
I,m in possession of a blower with a 6" dia (blades 1.5) 6 blade fan, outlet is 2.5". I am considering using this on a back blast type forge. Could someone give me a clue as to what maybe a suitable speed to run it at in this application. Thank You.
Where can you purchase the correct carbon rods that the were originally used? Ive made several inquiries and so far have not been able to locate a supplier.
On Ebay at the moment is a new side blast forge, 24"x 24", water cooled and fitted with a hood, air pipe is 1.5"dia
Some usefull information given in the listing re side blast forges, Buy Now Price is $599US.
Look under blacksmiths forge.
With a good drill bit and a pilot hole a Cole Drill is easier and almost as quick as a hand held electric on most holes 1/2" and over. They do not lock up and the bit keeps much cooler.
Need a 3/4" square hole through the centre of a piece of round bar 2"dia x 3" long. Have bored a 3/4" hole through
the centre.
Any advice on heating, punching etc would be greatly appreciated.