Jump to content
I Forge Iron

TheR3aper2099

Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

181 profile views
  1. Thank you Slag I am not concerned with the appearance just structural integrity. I am putting another layer of hellcote 3000 on before I apply this ITC-100HT, which should seal it up good.
  2. I used a layer of cleanburn refractory and then a layer of hellcote 3000 which is when I saw the rust spots and the hot spots as well.
  3. Hello! I am new to this forum but been smithing for 5 years. My gas forge has a few hot spots that show up during the initial light but then fade away once I’m up to heat. I have not had this happen before and I have just re-lined my propane forge. Also I have some odd looking rust spots that showed up this morning after working last night on the liner. Any ideas on what could cause that? Thank you in advance!
×
×
  • Create New...