I believe the mig tip orifice was the biggest problem. I changed it to a 0.030 because i had one on hand. it worked pretty well after that. I will measure the alignment in the morning but it could be the angle of the picture that makes it look off too. I wish i would have caught the "T" size being a 3/4"×3/4"×3/4" when i ordered it. I think im gonna order the right size "T" and replace it. But if the thing will get it to temperature i may just leave it. The mig tip made a huge difference tho. I only paid 15 buck for that burner so if i do end up replacing the "T" its not too big a deal for me. Thank you for taking the time to look at those pictures and respond! I appreciate the people here on this forum so much! I am learning more than i thought i would need to know when i began this project! Hopefully tomorrow i will be banging on some hot metal! I figure that if it all goes wrong i can have a gas heater for my shop and go back to my coal forge. Hah!!! Oh man i hope this thing works!!! Hah!! Well thanks again!!