Cornishdave

Your right yeah the thumb screw allows you to adjust the height of the mig nozzle in the tube. My problem I think was caused by the burner to deep in the forge with not enough gas pressure pushing. I’ve had it running again earlier and with a bit of tickling here and there the burner tube appears cooler. Planning some more practice running tomorow

Ok I’ll fire it up tomorrow try to get the pictures. It’s running propane at about 16psi

Doesn’t appear to be burning in the tube, have a very good light blue cone right at the tip of the flare in to the forge? What details would you need??

So I’m new to the forging scene got enrything up and running but seem to have a lot of heat in the burner tube with the flare end (in the forge) glowing red hot. its getting hot enough that even the mig nozzle is to hot to touch. Any advice welcomed thanks in advance dave