savage_sultin

Ok thanks. I wasn't sure if the cooler air would keep it cool. I think ill keep them short

this is the concept but I would bring the metal straw closer to the end maybe all the way to the edge. I was wondering about pre-ignition as well, but with cool air blowing over it constantly I thought it might not get that hot.

thanks, regarding the "3a. Pro tip #1: When doing your research, don't bother with the Search box up at the top of the page; it's pretty worthless. Go to google and include "site:iforgeiron.com" as one of your search terms." thats pretty much what I used but checking out google now. thank you im navigating through the site now, ive been forging for a while but just switching from Venturi to a ribbon burner

Hey folks, im new and this might be discussed before but when I searched I didnt see my question. im making a ribbon burner and for the holes im going to use stainless steel straws cast into the cement. would you think they would be fine? I dont see them being an issue, seen the pine ridge burner and they use a steel metering tubes