Joe E
-
Posts
9 -
Joined
-
Last visited
Content Type
Profiles
Forums
Articles
Gallery
Downloads
Events
Posts posted by Joe E
-
-
Frosty, should I also ridgidize the kawool that I will stuff in between the ribbon burner and the square body that holds the burner to keep the heat from chimney effect?
-
24 minutes ago, MCalvert said:
No no. My mistake. It plumbs directly into the pipe.
Thanks!
-
Thanks for all the replies y’all!
14 hours ago, MCalvert said:Mine goes from braided line to copper tube (flare), then flare to NPT adapter, then pressure gauge, then needle valve, then the nozzle. This was suggested to me so that I could set the max line pressure with the regulator and gauge, then fine tune with the needle valve depending on what the flame looks like. It helped me a ton. I set my max line pressure to 2psi, and then I know that I am tuning in that range with my gate valve and needle valve.
I forgot to say regulator to braided line, oops!
When you say nozzle, what part are you talkin about? Does the gas need to be fed into the pipe through a certain fitting or just through the 1/4” pipe? I have a Venturi burner that feeds with a .030 mug tip and was wondering if I need to do something similar with the ribbon setup.
-
It’s a blown burner
-
Greeting folks! I am building a ribbon burner forge and was looking for some plumbing advise. I have a regulator and hose and I have the 2x3/4” Tee that I have reduced The 3/4” down to 1/2”. Do I simply feed the gas to it through the needle valve or do I need something in between to reduce it more. Any advise/tips/tricks would be greatly appreciated. I posted this in the ribbon burner section but haven’t got a reply yet so I figured I’d try here. Thanks, Joe
-
Greetings everyone! I am in the process of putting together a ribbon burner forge and I was wondering if any of you would be so kind as to share how you ran the gas to the air pipe to feed propane in. I am planning on using 2” black iron pipe and I have a 2x 3/4” tee for the propane inlet but need some pointers on where to go from here. What size and type of fittings do i need? Is a gauge necessary? Any help would be appreciated! Thanks, Joe
-
Thank you Mr. Frosty! Very helpful info.
-
Greetings everyone! Is west Systems 40 a good ridgidizer for kaowool? Do I just mix and apply like paint if so? I know it’s been covered a little before but I wanted some definite info on it. I am building a ribbon burner forge and I would like to ridgidize the wool before coating with kastolite and metrikote. Thanks, Joe
Plumbing gas to ribbon burner
in Ribbon Burners
Posted
I got it figured out y’all. Not sure if it’s standard but it works.