Jump to content
I Forge Iron


  • Content Count

  • Joined

  • Last visited

Everything posted by Gary65

  1. Gary65


    Ok. I read thru (as much as I could before my eyes crossed) burners 101. Man that's a lot of info! I now see that I should have come here before watching all the crazies on YouTube. I settled on the side arm burner and believe I built it as described. Parts I used; 1-1/4" T Bushing 9" x 3/4" tube (one end of the threads cut off) Flare from Larry. 1/8" x 5" (bought it long, I wasn't sure how much adjustment was needed). Schedule 80. .35 mig tip. My question is based on the attached photo. Generally how far into the T does the mig tip sit?
  2. Gary65


    I don't have the choke on in the photo. My flare is 3/4" x 1" with the threads ground down. The intake is 3/4" x 1-1/2". I noticed the flame ignite's way down in the tube very close to the flare end. Where should I drill the intake holes?
  3. Gary65


    Hey people,Hoping for some feedback on the new torch I built. I've attached some photos in the hopes that someone could tell me if I need to (or not) do some tweaking.One is of it is with it lit with the gauge barely reading above 0. The other is it at 7 psi. The last is of the throat which is a reducer that is 3/4" x 1-1/2". The jet is 1/8" x 3" nipple with a #57 hole in a cap. I didn't do a water test to center the jet but I tend to have a good eye and centered it pretty well. I also slid the assembly in and out until the flame tried to go out (in both directions) and turned out the center o
  • Create New...