Jump to content
I Forge Iron

RHolly

Members
  • Posts

    8
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    Jackson, Ms

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Not much rebound with a hammer. Gonna grab a ball bearing and try it this weekend.
  2. I wire wheeled this Bay State anvil a bit. Top is still pretty rough. I can't tell if it had a table or not. Not sure if the face has or had a hardened steel plate.
  3. I have been going to the forge council meetings at the AG museum here in Jackson, Ms. Usually have a demonstrator and then we get in the forges. So I have been googling trying to find contact info for Richard Postman. Anyone have his contact info?
  4. I have been going to the forge council meetings at the AG museum here in Jackson, Ms. Usually have a demonstrator and then we get in the forges.
  5. I wonder if I try and resurface it would that ruin any potential value? Would like to use it but I do not want to make matters worse.
  6. Thanks for the response . It's in pretty bad shape. I was trying to figure out if it's worth trying to restore it or just clean it up and use it as a shop decoration.
  7. Had a friend give me this Bay State anvil. It may be in the 80lbs range. Its condition is pretty bad. I have googled info on bay state anvils but haven't found much about them. Anyone one have any info?
  8. Had a friend give this Bay State anvil. It may be in the 80lbs ranger . Its condition is pretty bad. I have googled info an bay state anvils but haven't found much about them. Anyone one have any info?
×
×
  • Create New...