Bill Mcclain

Frosty wondering if you can shed some light on why I have so much trouble getting my burner started I have to shut the regulator down almost to zero and then slowly increase the PSI. back it off and then increase it again and then finally it takes off and does good I'm wondering if I've got a bad regulator

Well got her all fired up finally. But not so sure that I should have put burnner in side instead of top my main heat is to one side and also having a issue with lighting have to turn regulator down an ease it to higher pressure which is max on 20 psi regulator

I assume both I ordered it of Amazon.com and it's under BBQ and it doesn't say anything about what size fitting just says 0 to 20 psi regulator and 10' hose . And just to be safe I made two burners 1 with 1/4 &1 with 3/8 that way I'll be ready lol

Got you I didn't mean no disrespect I appreciate you add your post and your time texting me I just didn't understand how you had yours hooked I was going straight from the propane tank with a barbecue hose . Thank you for your time and info. Bill

Cool I was buying a regulator with a 10-foot hose and that said 0 to 20 psi I just wanted to make sure that it would work but I'm builting Frosty's 3/4 ×6 burner he's calling for a 1/8 or 1/4 and the hose that I'm ordering is a 3/8 so I reckon I have to get a fitting to work for that

Thanks frosty . I just didn't know if 20 psi regulator would be enough also I've run into another problem my quarter by I will not let my hose attached from the propane tank I need 3/8 by 1/8 I think 1/4 × 1/8

3/4 x 6" what psi should I use. Will 0-20 psi regulator be ok

Thanks again for all the info.To all my forging friends.

Thanks again frosty. Can't wait to get fired up! Thanks & God bless

Thanks frosty. But I'm not sure what ur calling a threaded protector. I seen your post and if I'm right u said not a coupling the only thing that I have seen as far as a thread protector is plastic. .also is it hurting anything that I am putting my burner in almost horizontal instead of straight down. Thanks again. Bill

Sorry my bad it's a 6-inch T burner 3/4 inch and all the ads and information I can find on it tells how to build it but does not say what the flare is made out of and also how far it protrudes down in to the forge . And also if I should weld it to my tank or Forge using a barbecue propane tank for my Forge

I'm building a frosty 6-inch T burner but not quite sure on the mounting or how far inside the forge it should stick thru also confused on what the burner flare is Do I weld 6"nipple to my forge or what. Any help would be greatlyappreciated Trailrider

I'm building a frosty 6-inch T burner but not quite sure on the mounting or how far inside the forge it should stick thru also confused on what the burner flare is Do I weld 6"nipple to my forge or what. Any help would be greatlyappreciated Trailrider