Jump to content
I Forge Iron

agblea

Members
  • Posts

    10
  • Joined

  • Last visited

Posts posted by agblea

  1. I’m using quarter inch square tubing for legs cut at a 12 degree angle.  The pads I will be using is 1/2 inch plate.  The top plate that the anvil will sit on 1-1/8” solid plate.  When I place a level on the top plate , it’s spot on level in all directions. No wobble.  The anvil on the other hand wobbles on the plate, on the cement pad, on any Level Plain.  The foot of the anvil is not level.  It’s out closer to 5/16 of an inch horn side low.  Can I build with a Mig on the bottom of the foot of the anvil, and grind down to level? Then silicone the anvil when all is true, plain, and level?

    thanks

    freddie

  2. Hello everyone!  I have a 196lb Peter Wright.  Started to build a three leg stand.  The stand is level.  Placed the PW on top and noticed it was close to a half inch off towards the horn.  Turned the anvil up side down and the four corners are not level as well.  Do I shim between the stand?  Build on anvil foot with MIG? Suggestions? 

    Thanks

×
×
  • Create New...