Hello all! I'm not sure if this is the right section for this or of it should go in the Problem Solving section? Move the thread to the correct section if it needs to be. My Metals Lab teacher got a Torchmate Plasmacam(pretty sure that is its name)2x2. It's taken almost a year to get it going. One kid was able to get it cutting(after spending hours with tech support on the phone). My teacher(or someone else, or it just happened somehow) somehow messed up the settings and it won't cut now. Friend of mine and the teacher were finally able to get into the program and get it to move about the lines of the image, but it doesn't cut and the air cooling is sparatic(sometimes on, then goes off). If anyone can give some ideas to why it's doing this is much appreciated! Thanks!