Jump to content
I Forge Iron

Ironmike

Members
  • Posts

    63
  • Joined

  • Last visited

Everything posted by Ironmike

  1. Is it possible you could show us how you create your feathers, also are the feet forged . The Anatomy on your sculptures is gorgeous just like the real thing absolutely beautiful work, Ironmike
  2. Looks nice Daswulf, Are you using Tig for your welds? Ironmike
  3. Littlemilligan, Beautiful job!! How long did it take? Looks like alot of detail in that and alot of time Ironmike
  4. If you do a seach for Rhino in the seach box,I think you will find what you are looking for here.I will say Steve makes a good anvil and also has some nice hardies to boot. I like his Touchmark Tools as well Ironmike
  5. Nice, Both are nice, The clock does catch your eye though Ironmike
  6. A good source for these type of tools that you're going to modify is Harbor Freight because you don't feel bad about chopping them up, But I have been known to use a snap-on when I have been in a bind and need to get the job done. Ironmike
  7. If you want to make a longer socket, take your chopsaw and cut the drive end off of the socket, and using a piece of tubing same diameter as a socket cut the tubing the length you want the socket and weld back together I also suggest using a 6 point socket,I make a lot of specialty tools this way Ironmike
  8. Excellent -Very nice! I love your work man, You are an Artist in every sense of the word Ironmike
  9. Natkova ,That power supply is way to small 1000ma or 1amp,That blower will draw anywhere from about 3amps to 10amps on high speed Ironmike
  10. Charles, My horses run on electric, every time they touch the electric fence Ironmike
  11. You can run it off that battery if it,s charged,You need 12volt. The same thing the car it came out of ran on (12volt) Or get a power supply that puts out 12volt Dc Ironmike
  12. Natkova, By the way That blower motor is 12v-DC you will need some sort of 12v DC power source Car battery? ect Ironmike
  13. Other way is ,by the looks of it two are going from the resistor to the plug, leaving two to the plug one being ground and the other your high speed,if you hook them up backwards the motor will run backwards then just reverse them Ironmike
  14. It looks to be three speed, if there's four wires in that plug one is ground the other are the speeds one being ground if only three in the plug no ground then you have to ground the motor housing it's hard to tell by your pic, it does look like the resistor was spliced in at one time.Two speeds through the resistor then third direct for high and ground Ironmike
  15. Can you post a pic of the bottom? Ironmike
  16. Fatfudd, That is really nice and the dies are super! I have alot of machines that I have used for other things then what they were intended for thru the years, It's called ingenuity Ironmike
  17. Nice forge Drew, Main thing is it rolls,You can allways throw somthing over the gap to get over it Ironmike
  18. Ironmike

    wrights vise

    How wide are the Jaws? Ironmike
  19. Ironmike

    wrights vise

    Looks like the front jaw is down,That would be the pivot bolt like Anvilman says, That plumbing looking fitting may be the right part but in backwards it's hard to tell by the Pics Ironmike
  20. Hi Steve, I'm in OP right next door to you PM me when you get a chance Ironmike
×
×
  • Create New...