Hello all,
After reading some threads, I am thinking this is my type of community. I am a beginner looking to become better at forging knives. I have aquired the basics. a single burner gas forge made from a helium tank that gets almost white hot. a 55# ASO from HF. 3# cross pein hammer. 2 lb hammer. some homemade rebar tongs and lots of interest.
while Scavenging for spikes I found this thing buried with just an inch showing. I am not sure what it was, but I know what I would like it be!
My questions are:
1. What the heck was it?
2. should I cut the ends off stand it on one end in a bucket of sand to dampen the ring this thing makes?(it weighs 66Lbs without the other part attached, 86 with)
3. how could I use the other part?
Any advise or info even if not related to the questions is very much appreciated!