IForgeIron Blueprints
Copyright 2002 - 2009 IFORGEIRON, All rights reserved.
BP1057 Punching Holes on the Diamond
This is part four of a five part series.
by Uri Hofi
Punching hole in 5/8 inch square on the diamond.
Forge the square steel on the round bick on the diamond from on side and. Get the roun bick pattern on the bottom tns right line above until you have a land of a bit more then 3/8 inches .
Turn around and on the center of the land punch dowen to the anvil. Turn around once more and punch out. One can see the punch out.
The finished hole.
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.