IForgeIron Blueprints
Copyright 2002 - 2009 IFORGEIRON, All rights reserved.
BP1043 Curtain Rod or Bar Holder
by Uri Hofi
A curtain bar holder B roof nail C drawer handle
This Blueprint has 3 sections
Up the roof nail Middle the drawer handle Bottom the curtain bar holder We start with a ''curtain bar holder''
The three elements are based on the same form for different use
Me.
The steel in this case is 3/8'' round.
The set--- anvil, cast hammer, forge, rosebud, hardie and vise
Cut hit the hardie in a way to get a small point as shone above.
The importance will be explained later.
Flat 3-1/2 inch long on the anvil with the hammer to 5 mm (a bit more then 3/16 inch).
Forge this form when the hammer is a the ired out of the anvil. Get a 5/32 inch neck.
Pot the form ''standing'' on the anvil when the step is out and push the step to the edge of the anvil and forge with the pein of the hammer to get the for me (remember the small point when cut ,because of this type of cut ,when forging with the pein automatically we get the rounded form).
Local heat with the rosebud.
And hammer to wards the vise to get nice 90 degrees.
Hold in the vise 1/8 inch out of the jaws.
Correct the corner.
Heat the corner in the forge.
On the round bick with the hammer pein forge to get a nice corner.
Form a hook on the point round bick of the anvil.
Cut on the hardie and prepare for the next one.
Forging the point.
The finished ''curtain bar holder''.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.