Jump to content
I Forge Iron

Point Threads

Don Shears

The mounting threads used on two different loggers pole points. Both points are about 1/2 inch sq. stock. The upper has threads made by using a commercial die set. The lower was threaded by twisting the stock. Mounting these points in poles required drilling a pilot hole in the pole end, mounting a ferrule to reinforce the pole end, then threading the point into the hole.


© Don Shears 31 July 2013

From the category:


· 369 images
  • 369 images
  • 132 image comments

Recommended Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...