#8

Ten Hammers
Sign in to follow this  

I forged new fork arms (4 pieces) and bored them to accept the bolt through the hammer head. I bored the bolt to allow grease to make it into the area where the forks pivot and tapped the end to accept a zerk. The slides for the head are exceptionally smooth after I re-adjusted them. I use bar and chain oil on them. Also note the old driver belt behind the head in this pic. I cut some baler belt to replace it and got the length right and then took it to town and had splices put in it.

Sign in to follow this  
From the album:

Ten Hammers

  • 33 images
  • 0 comments
  • 25 image comments


Recommended Comments

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.