twisting 6ft long stock?

[ChrisB]

I am thinking about twisting together three pieces of 1/4 round stock. To make legs for a pub height (40") table. I have a gasser forge that is set up with a back door to pass thru. I'm thinking I'll arc weld the three together at each end then heat a section at a time and keep putting one end in the vise to twist each section.

I would appreciate any ideas one may have to keep this operation simple, painless and cost effective.

[Zsartell]

That should work just fine. I've done long pieces in my coal forge before, you just have to control the heat with water and keep an eye on how much you are twisting and where it is twisting. (It's easier than it sounds)

[Glenn]

Why not move the forge and vise closer together and make the twist in the fire?

[HWooldridge]

Long twists are easily done as you suggest but I find it more efficient to use a torch to add heat to slower twisting areas that have cooled rather than use water to cool hot spots. It may be nothing more than "one man's opinion" but I believe it is more easily controlled and keeps the piece hot for the next part of the twist.

[civilwarblacksmith]

You can also heat longer areas on the steel by moving it back and forth along the length until a long section is at temperature. As long as you have heated it up it will not take as long to reheat as you pull it from the fire to do that section.

[triw]

I did the same thing and I took a piece of 2" x 1/4" stock and drilled holes 9/32" holes in the center of the stock. The holes formed a triangle and used this to twist with while the stock was in the forge. The front of the stock was in a vice and I kept moving the twisted stock out into the vice. I also kept the loose ends in a piece of 10' pipe to keep the ends in line for easier handling.
I did this twice so I had two pieces about 19 feet long whick I welded togeather to form a 38' rope. I then formed this into a 4' high lasso with a copper hondo and then curled the remainder going back for a saddle rack. The friend who wanted it won the saddle in a calf roping event.

[KevinD]

Originally Posted by triw

so I had two pieces about 19 feet long whick I welded togeather to form a 38' rope. I then formed this into a 4' high lasso with a copper hondo and then curled the remainder going back for a saddle rack. The friend who wanted it won the saddle in a calf roping event.

That sounds cool. Got any pics?

[ironantlerforge]

I would also recommend the torch method as the easer way for a controlled even twist.

but, what ever works

IAF

[the_sandy_creek_forge]

I've never tried it.... but... would 3 pieces of 1/4" be too much to cold twist? I've seen long sections of 1/2" square twisted cold (just over twist a bit to accommodate for some spring back). Just a thought.

-Aaron @ the SCF

[Dale Russell]

ChrisB ,,
you need to build yourself something like this

Twister - Blacksmith Photo Gallery

Does these " easy " COLD

Twin outdoor candle / tinnie spike - Blacksmith Photo Gallery

That twist in the uprite is 18 mm x 6 mm ( 3/4" x 1/4" )