I Forge Iron
Blacksmith and Metalworking Forum
anvil marks
This is a discussion on anvil marks within the Blacksmithin' forums, part of the Blacksmithing category; someone knows the brand, type or mark of an anvil? it have this draw at a side. it is an ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
05-10-2008, 07:11 PM
| |||
| |||
 anvil marks
someone knows the brand, type or mark of an anvil? it have this draw at a side. it is an arm and a hammer, some illegible letters in top and bottom of the oval, weights 35 lb. many tranks Last edited by Víctor Zamora; 05-10-2008 at 07:24 PM.  |
|
05-10-2008, 07:26 PM
| |||
| |||
|
Hello, Victor, the brand of your anvil Is VULCAN, they used this trademark, it is a cast iron anvil with a hard face. Nice Anvil
__________________ Heat , Pound it, and Enjoy. Matt |
|
05-10-2008, 09:13 PM
| |||
| |||
|
Thank you a lot Alabama...
|
|
05-11-2008, 04:03 PM
| |||
| |||
|
Vulcans tend to have a thinner steel face so be sure *NOT* to remove any of it trying to "clean it up". They are a quiet anvil and so good for smiths with close neighbors. That steel face makes them Way better than an HF ASO.
__________________ Thomas |
Linear Mode
