I Forge Iron
Blacksmith and Metalworking Forum
Anchor pictures
This is a discussion on Anchor pictures within the Blacksmithin' forums, part of the Blacksmithing category; Here is some pictures of the anchor I forged, from 1/2 inch square stock. I know the top part is ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
04-15-2007, 10:21 PM
| ||||
| ||||
 Anchor pictures
Here is some pictures of the anchor I forged, from 1/2 inch square stock. I know the top part is wrong, I still need to twist another 1/4 turn. The bottom got a little messed up, the mortis and tenon joint I was going to do thinned out a bit too much, and broke, so I just sorta tapered the ends of the two feet and wrapped them around. Definately a display/art peice, not suitable really for an anchor, then next one iwll be though, i guarentee  . The upper ring, is sort of a new technique I think I developed(I have never seen it before atleast ). Enjoy.
__________________ Founder and first member of the SBA, The Space Blacksmith's Association! Last edited by ApprenticeMan; 04-15-2007 at 11:15 PM.  |
|
04-16-2007, 01:25 AM
| ||||
| ||||
| Quote:
__________________ Founder and first member of the SBA, The Space Blacksmith's Association! |
 |
« Refacing an anvil
|
Huge Anvil »
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -4. The time now is 03:39 PM.
