I Forge Iron
Blacksmith and Metalworking Forum
ACBA Gate - side panel
This is a discussion on ACBA Gate - side panel within the Blacksmithin' forums, part of the Blacksmithing category; Excellent, I was afraid that it was just another place where they taught folks to drill the holes and use ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
05-14-2008, 11:04 PM
| |||
| |||
Excellent, I was afraid that it was just another place where they taught folks to drill the holes and use a lathe or plug bit to make the tenons. It's nice to see that they're living up to how they've presented themselves to the traditional building trades and organizations. I might just call them. However this summer I'll be spending at Touchstone as the Studio Resident Associate for the Blacksmith shop. I'll see where I want to go with my work after that.  |
|
05-15-2008, 06:28 PM
| |||
| |||
|
I wish I had a picture of the die we made for it. If I could get to school, I'd get one.
|
|
05-15-2008, 07:27 PM
| |||
| |||
|
That is work to be proud of and to show off. Thanks for shareing it with us.
|
Linear Mode
