I Forge Iron
Blacksmith and Metalworking Forum
Boss Power Hammer
This is a discussion on Boss Power Hammer within the Power Hammers forums, part of the Blacksmithing category; Do any of you have a Boss Power Hammer? These were made in Dubuque, IA in the early 1900's and ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
03-29-2008, 11:04 PM
| |||
| |||
 Boss Power Hammer
Do any of you have a Boss Power Hammer? These were made in Dubuque, IA in the early 1900's and other places later on. The hammer has a large cast "anvil" and a steel tube pipe frame with the main shaft, clutch, pitman, etc. mounted to plates on top of the tubes. Where do you find the size / weight? Good hammers? Any other data would be appreciated. Jim Carothers, Saltfork Craftsmen ABA, Oklahoma.
 |
|
12-10-2008, 09:48 PM
| |||
| |||
| New on Site
HI: Eric Sprado here. Was farrier for 25 years and am now(after 15 year hiatus)starting to smack some iron. Am trying to reply to man who was asking about Boss power hammer. I just bought one this week and,coincidentally,so did my friend Ben Barrett. They both are still in "shaft mode" and need motors installed. Any help out there? Thanks, Eric Sprado
|
Linear Mode
