I Forge Iron
Blacksmith and Metalworking Forum
Show me your Machinist Vise
This is a discussion on Show me your Machinist Vise within the Machinery General Discussions forums, part of the Machinists category; I machined this little fella for my small camel back drill press. 6 inch rule clamped in the vise in ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
12-27-2007, 09:18 PM
| ||||
| ||||
I machined this little fella for my small camel back drill press. 6 inch rule clamped in the vise in the second photo.
__________________ Irnsrgn Knowledge must be shared or it lies dead in the mind. The Blacksmith must use Hammer and Flame to force the iron down the path of his own choosing. I usually find it much easier to be wrong once in while than to try to be perfect.  |
|
12-28-2007, 05:28 PM
| ||||
| ||||
| Quote:
 |
|
12-28-2007, 06:19 PM
| ||||
| ||||
|
I`ve only used it once so far! LOL
|
|
12-31-2007, 07:27 PM
| |||
| |||
I made mine in 1990 from a piece of CRS 2" W x 4 1/2" L and 1 1/2" H. Screw is just a fine thread bolt with another bolt for a handle. I made it at work while running a big lathe and the milling machine was always just sitting there so i put it to a good use.  The South Bend Lathe 6" rule was my great grandads and he worked at the Studebaker factory in SB Ind...Bob |
 |
« hammer adjustment
|
Bender »
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -4. The time now is 10:46 PM.
