Blacksmith and Metalworking Forum
This is a discussion on Questions About a Free Massive Diesel Generator within the Machinery General Discussions forums, part of the Machinists category; Hi Friends, I'm a bit over my head on this one (what else is new). The manager of the ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
| |||
| Have an electrician disconnect the transfer switch from the building main. Make sure you get the transfer switch, most of the exhaust system, and everything else. Have A tow truck operator move it with a large ramp truck. Keep the exhaust outlet covered, and it can be stored outdoors for quite a while. If it is a dark, damp basement, bar the engine over first, before you invest in removing it. Most standby generators have had very little use. |
| ||||
| copper is $150 a pound now and scrapiron was $250 a ton, don't know about cast. If you are thinking about running it, check with your bank about a loan before ordering fuel. plan B, find a salvager that will take it out and pay you for it taboot.
__________________ Irnsrgn Knowledge must be shared or it lies dead in the mind. The Blacksmith must use Hammer and Flame to force the iron down the path of his own choosing. I usually find it much easier to be wrong once in while than to try to be perfect. |
| |||
| If you are thinking about junking this or any other generator, please reconsider. This unit can be made to run on many different fuels, some of wich are available free. Also, large amounts of deisel and #2 heating oil, and jet fuel are hauled away at cost to the former owner, all of wich will run in a deisel. It would also serve greatly as a backup generator, for ocasional use, when some other alternative power sorce was temporarily out of order. The demand for generators like this in third world countrys is unfillable. Deisels can run on methane, propane, natural gas(methane), wood gas, coal gas, water gas, vegtable oil, used vegetable oil, algae oil and recycled motor oil. The gen end by it self can be used for steam or hydro. |
| ||||
| arftist Go to the top of the forum page and click on user cp click on edit profile go to the bottom of the page, enter your location and save. We would like to know where in the world you are located.
__________________ Tools do not make the blacksmith, the blacksmith makes the tools. gc If someone questions your standards, they are not high enough. |