I Forge Iron
Blacksmith and Metalworking Forum
Horizontal Band Saw Rebuild
This is a discussion on Horizontal Band Saw Rebuild within the Machinery General Discussions forums, part of the Machinists category; Yes, you do need the guides whether cutting vertical or horizontal. However, if all that is missing is the rollers ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
08-07-2007, 12:14 PM
| ||||
| ||||
Yes, you do need the guides whether cutting vertical or horizontal. However, if all that is missing is the rollers themselves, you should be able to find them at a well stocked hardware store such as True Value.
__________________ While never issued evenly, common sense should always be deployed uniformly. Semper Fi! Its not just for breakfast anymore!!  |
|
08-07-2007, 02:15 PM
| ||||
| ||||
|
It wasn't just the rollers. It was the mounts and everything. I left it sitting. I had a run around looking at welders and didn't have time to go back. I wanted to take another look at where stuff should be mounted to the frame, etc.. Now I just want to pick up some scrap for welding, and probably a 4 1/2 inch grinder with a cut off saw on it  |
 |
« 123 block
|
Changing tolerances »
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT -4. The time now is 11:50 PM.
