I Forge Iron
Blacksmith and Metalworking Forum
Anvil 4inch square post anvil identification
This is a discussion on Anvil 4inch square post anvil identification within the Machinery General Discussions forums, part of the Machinists category; don't discount cast iron for a base, look at the bottom of this anvil, its a cream seperator base with ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
11-19-2007, 08:00 PM
| ||||
| ||||
don't discount cast iron for a base, look at the bottom of this anvil, its a cream seperator base with small thin cast iron legs. it has been in the shop all the 55 years I was there and got lots of use some of it hard use with a sledge.
__________________ Irnsrgn Knowledge must be shared or it lies dead in the mind. The Blacksmith must use Hammer and Flame to force the iron down the path of his own choosing. I usually find it much easier to be wrong once in while than to try to be perfect.  |
Linear Mode
