Forge Trailer

[RBrown]

Here is the list of tools we will need for the forge trailer. We may
> have to have some take-backs in order to have sufficent tooling for
> the Conference, but this is what we would like to have on the trailer permanently: Let Mike or Barry know what you are donating so that we don't have too many of each.
>
> For every forging station:
>
>
> 2 - 2-1/2 pound cross pein hammer
> 1-1/2 pound ball pein hammer
> Hot hardy
> Center punch
> Ruler and or Tape measurer
> Hand wire brush
> Tongs:
> V-bit - 1/4", 3/8", 1/2", 3/4"
> Flat
> Flatbar/boxjaw - 3/4", 1"
> Ring (actually for holding non handled punches)
>
>
> One for every two forging stations:
> Small post Vice (~4") (One from Barry, One from Phil - already
> donated) Files - flat, half round, square, and round
> 6-8 pound sledge hammer
> Handled hot cut
> Round punches (handled or non-handled) 1/4" to 1/2"
> Square punches (handled or non-handled) 1/4" to 1/2"
> Hacksaw

Dan Tull is providing hacksaw,wire brush, handled hot cut,sledge, couple of files, and a small ball pien hammer. Will bring to Madison.

[Barry Myers]

I have finally had the time and a good reason to check it out. Thanks Russ for posting this for us. I am going to take the vise over to Mike tomorrow.

For you who are making tools, don't forget to put your mark on them. Barry