Blacksmith and Metalworking Forum
This is a discussion on February, 2008 within the Monthly Projects forums, part of the Blacksmithing category; take the preybarrr, genttely take apart the car radio, reasemble it with modifications so that it rons on plasma (use ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
| |||
|
Place one end of a 4x4 on the ground the other on a cement block, back up truck. Place a second block and board under the axle and remove first board. Cut off old flat tire with O/A, then weld inside rim of spare to outside of attached rim. Drive to hammer-in. Chuck |
| |||
|
Heat and forge the end of the prybar to fit the drive on the socket ( using the hitch ball for anvil ). Watchfob makes good hammer for this part. Use reciever to bend prybar for handle you just forged. Crack all the nuts on the flat while on ground. Lever the truck up on the block and change flat. Send video of entire episode to Youtube for worldwide viewing ( using your cellphone ). Life is good. You could of course just call Junior and have him come out in his service truck.
__________________ " It ain't real if it ain't forged " Last edited by Ten Hammers; 04-12-2008 at 06:51 AM. |