I Forge Iron
Blacksmith and Metalworking Forum
Straighening rollers
This is a discussion on Straighening rollers within the Problem Solving forums, part of the Blacksmithing category; When you texture a bar, it becomes thinner, wider, and longer. Depending on the texture,and the hammer operator, it could ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
06-12-2008, 11:16 PM
| |||
| |||
 When you texture a bar, it becomes thinner, wider, and longer. Depending on the texture,and the hammer operator, it could become more thin and wide in one spot along a bar than another spot 6 inches away. Would a precision roller be able to deal with these irregularities without making a flat spot, or rolling a burr on an edge? I don't know, that's why i ask..  |
|
06-13-2008, 01:09 AM
| ||||
| ||||
| John : that's a good advice I'll have to try 10x a lot |
Linear Mode
