I Forge Iron
Blacksmith and Metalworking Forum
galvanized chimney pipe
This is a discussion on galvanized chimney pipe within the Problem Solving forums, part of the Blacksmithing category; Can you use galvy chimney pipe for a forge side draft hood? Thats all homedepot has and its even in ...
| |||||||
| Register | FAQ | Calendar | Search | Today's Posts | Mark Forums Read |
10-12-2008, 01:14 PM
| ||||
| ||||
 galvanized chimney pipe
Can you use galvy chimney pipe for a forge side draft hood? Thats all homedepot has and its even in 12 inch
__________________ Brandon Strange, Pround to be a kidsmith  Member of the KAOA!!! CHECK OUT THE KAOA! www.thekaoa.com  |
|
10-12-2008, 02:07 PM
| |||
| |||
|
i have used it before with no problems as for a side draft i have never used it for that the galvinized is not that thick on the mine rusted out after a few years and as long as chimney is flowing air it shouldn't get hot enough to burn the galv. off
|
|
10-12-2008, 02:21 PM
| ||||
| ||||
|
I think i may be a bit lucky because when i dident know much bout galvy u put a piece of it above my forge and all the galvy burned off but i never got sick.. Pic attached forge 4 - Blacksmith Photo Gallery
__________________ Brandon Strange, Pround to be a kidsmith Member of the KAOA!!! CHECK OUT THE KAOA! www.thekaoa.com |
|
10-12-2008, 05:55 PM
| |||
| |||
|
i see what you mean sabre i had my pipe conected to a hood over the old forge i made many years ago so the hood may have took most of the heat and that was made out of a old tank that was steel that i painted with stove paint
|
Linear Mode
