Blacksmith Forum

I Forge Iron

Blacksmith and Metalworking Forum

 

chimney problems

This is a discussion on chimney problems within the Problem Solving forums, part of the Blacksmithing category; If your chimney pipe is too small, you could try a wind turbine attic ventilator . They work good on ...


Go Back   Blacksmith Forum > Blacksmithing > Problem Solving

Register FAQ Calendar Search Today's Posts Mark Forums Read

Notices

Reply

 

LinkBack Thread Tools Display Modes
  #11 (permalink)  
Old 05-17-2008, 11:39 PM
Junior Member
 
Join Date: Aug 2007
Location: Grand Island, Nebraska
Posts: 26
Default

If your chimney pipe is too small, you could try a wind turbine attic ventilator. They work good on even mildly windy days. The best solution is to have a side draft chimney with an opening within 6 inches of the firepot, no larger than 10 inch by 15 inch (150 sq. inches), at least a 12 inch diameter flu pipe (14 inch is better and 16 inch is even better than that) that doesn't have any elbows or bends, is at least 16 ft. tall, and at least 2 ft. taller than anything within 10 ft. of the chimney. Also, trees and buildings that are close can affect the chimney depending on which direction the wind is blowing. Also keep the bottom of any chimney caps above the chimney at least as high as the diameter of the pipe.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Forum Jump


All times are GMT -4. The time now is 05:26 PM.


Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.2.0