 resurfacing an anvil
I picked up a 55# anvil that was abused badly. I was thinking about resurfacing so that my younger sons could use it. The thought was to have a piece of AR500 3/8" thick lazer cut with the appropriate holes and then either weld it to the top or sweat in on or even braze it on. What is your guys opinion? For those that do not know what AR steel is; it is an abrasion resistant plate that stands up to impact extremely well. I use it on targets. It will take a .308 round at 100 yrds with out even so much as putting a dent into it.
|