[Hofi]

Apprenticeman Hello And Hi

The Anvil Is Having Three Legs Because Of It The Anvil Is Always Leveld To The Ground
The Three Legs System Permits You To Stand As Near To The Anvil And You Dont Have To Bend Yourself .
Because Of The Glue The Anvil And The Base Are One Unit And Very Solid
The Round Beack (cone Side) Is Not! Round It Is Having Three Edifferent Raduses To Help You Forge Different Formes
The Base Is Having To Ports Or Bays That Are Open To The Ground Both Sides Of The Anvile You Can Use Them To Straighten Steel Or Different Elements
An Uper Sharp Stage 90 Degrees To The Anvol Neer The Hardie Hole
That Alows You To Forge Elements With Small Opening Some Steel That You Cut With A Chiesle And You Want To Forge Both Sides Without Dameging.
You Can Also Aligen Formes Being Suported On The Anvil And The Stage.
When Forgin Holes The Verity Of Prichel Holes 1/2-5/8-7/8-11/8''
Gives You The Possbilily To Punch The Hole Without Speciel Tooling.
The Short Drifts That I Use For The Punching Are Falling Into The Water Bowl That Is Always Under The Holes (you Can Not See It In The Fotos, It Was Taken Away For Transport)
Because Of The Ports On Both Sides Of The Anvil You Can Clamm Big Steel To The Anvil And Suport It On A Piece Of Steel On The Ground (much Better The The Vise).

Thank You For Your Interest

Uri Hofi