This is my design of anvil base for my ''HOFI'' anvil and for ALL the others too.
steel plate 13/4'' cut to the anvil base pattern.
two conicel pins are seatting into the anvil to hold it
a water can dowen the line of prichel holes
the 3 legs are from RHS steel 2x4'' cut in 23 degrees with a steel plate on the bottom.
the toiols trat is swiwel and hight adjust.
the plat is grinded and the bottom of the anvil too . between them there is a thin layer of sikaflex 11 fc that takes away the noise of forging and acts like a spring while forging
Hofi
|