Philip
I built some for a mitsubishi 15 hp 3/8 X3 Flat bar with 1X1 CR teeth. 4 holes in bucket teeth welded to FB. Add on forks were 3in
channel tapered tips with skid plates. Rear uprights to top of bucket with a hinge pin setup. forks 1 in below bucket edge. Use as wide a rear track as possible. I used a 400lb weight bar and loaded
tires. Make sure to add a sub frame to the rear end. Mine cracked the block at the bellhousing. 1000lbs on the front. OOPS
Ken
|