Since you are using a torch to join the socket to the chisel I would make a cone by rolling the sheet then torch weld the seam. or MIG/TIG if you have it.
I have a set up for flowers as you describe and I think you won't get what you envision. The sheet will wrinkle and need to be smoothed in several intermediate steps. as well the steel will be stretched and thinned where it really needs to be thickest.
For an example of what you are looking at doing see the Rafi Rose in the blueprints
BP1005 Rafi Rose. Yes the effect is intentional But that is the effect that you wil;l get even without trying for it. This blueprint technique capitalizes on the wrinkiling that does occur. Also when I try to form my flowers and get impatient I usually punch through the center.
Good luck
|